Page 1
Connect the the two halves of the power Power on your printer. printer and plug the other end into a USB cable and plug into the power jack socket. Note: It is important that your LabelTac printer ® port on your computer.
Check out videos on loading supplies and learn some helpful label making tips on our YouTube channel youtube.com/labeltac Need some more help with your printer? labeltac.com/support 1-877-356-6584 LabelTac Pro X REFERENCE GUIDE ®...
Press the “Menu” button to enter the main menu. Use the “Cross” button to select the item on main menu. The selected item will turn red. Press the “Feed” button to enter the setting list. LabelTac Pro X REFERENCE GUIDE ®...
Shift Y List Images Reference X List Formats Reference Y List Setup Control Code Page Prefix Format Country Prefix Delimiter Char Media Power Up Media Power Up Label Top Left Position Reprint Mode Format Convert LabelTac Pro X REFERENCE GUIDE ®...
Page 5
This “TSPL2” category can set up the printer settings for TSPL2. Speed Density None Direction Batch Mode Print Mode Peeler Mode Offset Cutter Mode Menu TSPL Shift X Cutter Batch Shift Y Reference X Reference Y Code Page Country LabelTac Pro X REFERENCE GUIDE ®...
Page 6
Use this item to set the code page of international character set. Print mode Use this option to set the country code. Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will overwrite the settings set from the panel. LabelTac Pro X REFERENCE GUIDE ®...
Page 7
Menu ZPL2 Feed Media Power Up Calibration Length No Motion Head Close Label Top Enabled Left Position Disabled Reprint Mode None 150 ->300 150 -> 600 Format Convert 200 -> 600 300 -> 600 LabelTac Pro X REFERENCE GUIDE ®...
(dpi) value; the second, the dpi to which you would like to scale. Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will overwrite the settings set from the panel. LabelTac Pro X REFERENCE GUIDE ®...
Page 9
Auto This option is used to set the maximum length for label calibration. Maximum Length 254mm This function can set the minimum paper length and maximum gap/bline Advanced length for auto-calibrate the sensor sensitivity. LabelTac Pro X REFERENCE GUIDE ®...
This item is used to set the RS-232 parity. Parity None This item is used to set the RS-232 Data Bits. Data Bits This item is used to set the RS-232 Stop Bits. Stop Bit(s) LabelTac Pro X REFERENCE GUIDE ®...
Page 11
Bluetooth PIN Code Item Description Default This item is used to set the local name for Bluetooth. Bluetooth Name BT-SPP This item is used to set the local PIN code for Bluetooth. Bluetooth PIN Code 0000 LabelTac Pro X REFERENCE GUIDE ®...
Use this menu to show, delete and run (.BAS) the files saved in the printer FLASH Flash memory. Use this menu to show, delete and run (.BAS) the files saved in the printer CARD Card memory. LabelTac Pro X REFERENCE GUIDE ®...
Firmware checksum Printer S/N Configuration file System date System time Printed mileage (meter) Cutting counter Print speed (inch/sec) Print darkness Label size (inch) Gap diestance (inch) Gap/black mark sensor intention Code page Country code LabelTac Pro X REFERENCE GUIDE ®...
Page 14
Printer head close motion Note: ZPL is emulating for Zebra® language. RS232 serial port configuration Numbers of download files Total & available memory space Print head check pattern Note: Checking dot damage requires 4” wide paper width. LabelTac Pro X REFERENCE GUIDE ®...
It allows users or engineers to verify and debug the program. Diagnostics Dump Mode Menu Note: Dump mode requires 4” wide paper width. LabelTac Pro X REFERENCE GUIDE ®...