Adjusting The Speaker Volume Balance; Adjusting The Sub-Woofer Level - Sanyo DWM-4500 Instruction Manual

Adjusting the Speaker Volume Balance

This unit is set to the standard level before shipping from the
factory. You may not need any adjustment.
However, depending on the size of the room and the placement
of the speakers, you may benefit from a fine adjustment.
In this case, follow the steps below. Please use the remote
control when the test tone sounds.
Note:
Do not connect the headphones.
1. Press [FUNCTION] to select "DVD/CD".
2. Press [n] to stop playback completely.
3. Press [TEST] on the remote control.
The "Speaker" screen appears on the TV screen.
"FNT-L 0" appears on the display.
The test tone will be heard from each speaker sequentially as
follows:
TV screen FL display
Front-L FNT-L 0
Center CENT 0
Front-R FNT-R 0
Surround-R SUR-R 0
Surround-L SUR-L 0
Note:
There are Surround left and right speakers in the rear
speaker.
4. Press [VOLUME] + or - until the test tone becomes a
comfortable level.
5. If the test tone level is not the same from each speaker, press
[p] or [o] to adjust it while the speaker is activated.
The level appears on the TV screen and display.
Front-L: "-10" ~ "0" appears.
Center: "-10" ~ "+10" appears.
Front-R: "-10" ~ "0" appears.
Surround-R: "-10" ~ "+10" appears.
Surround-L: "-10" ~ "+10" appears.
If necessary, repeat this step again.
6. Press [TEST] to turn the test tone off.
Note:
If no adjustments are made, the original display returns after
the test tone has cycled around 5 times.
Speaker
Front left speaker
Center speaker
Front right speaker
Rear (surround right) speaker
Rear (surround left) speaker

Adjusting the Sub-woofer Level

Note:
Do not connect the headphones.
1. Press [TRIM] while holding [SHIFT] down.
"FNT-L 0" appears on the display.
Note: No test tone.
2. Press [ENTER] repeatedly to select "SUB.W 0".
Note:
Each time the button is pressed, the display will show the
selected speaker and tone level.
3. Press [p] or [o] to adjust the level as desired.
SUB.W: "-10" ~ "+10" appears.
Note:
If another speaker is selected, the level can also be changed
as above.
4. Press [TRIM] while holding [SHIFT] down to turn it off.
Note:
If no adjustments are made, the original display returns after
approximately 10 seconds.
IMPORTANT INFORMATION:
Set the delay time for your center and surround speakers. See
"Setting Audio" on page E36.
-E19-