Manual presetting
1. Tune in the station to be preset as described in "Automatic/
Manual Tuning".
2. Press [PROGRAM/RANDOM].
"PGM" blinks.
PGM
3. While "PGM" is blinking, press [PRESET +] or [- PRESET] to
select the channel to be preset.
•
The number buttons on the remote control can also be
used.
•
In this example, the channel is "9".
PGM
4. While "PGM" is blinking, press [ENTER].
•
In this example, "103.1 MHz" FM station is preset on FM
channel 9.
PGM
PGM
5. Repeat steps above to add more preset stations.
•
When presetting a new station, the previous preset station is
cleared.
Listening to Preset Stations
Preset tuning
1. Press [TUNE/BAND] to select FM or AM.
2. Press [PRESET +] or [- PRESET] briefly to select the desired
channel.
•
If using the number buttons, press the number button(s),
then press [ENTER].
Preset scan tuning
1. Press [TUNE/BAND] to select FM or AM.
2. Press [PRESET +] for at least 1 second.
•
The channel number appears.
•
The preset stations are selected in sequence for
approximately five seconds each.
3. Press [PRESET +] when the desired station has been
selected. Preset scanning will stop.
When beat interference is heard
A high-pitched noise called "beat" is sometimes heard during
reception of radio broadcasts.
If this occurs, while holding [n] down on the front panel, press
[TEST] on the remote control to select "bc-A" or "bc-B". Select
the setting that gives the best results.
2
ST
4
ST
ST
ST
Changing the reception frequencies
It is not necessary to perform this procedure in the U.S. and
Canada.
1. Select the band to be changed.
2. While holding [n] down on the front panel, press [PROGRAM/
RANDOM] on the remote control.
To return the original setting, repeat steps above.
AM:
520 ~ 1710 kHz (10 kHz steps)
522 ~ 1710 kHz (9 kHz steps)
FM:
87.9 ~ 107.9 MHz (200 kHz steps)
87.5 ~ 108.0 MHz (50 kHz steps)
-E37-
Number
buttons
3
Number
buttons
1
Enter
2