Disarming After Alarm Condition - Scantronic 9600 User Manual

7
D
ISARMING
Note 1
if display shows
INVALID CODE YES/
NO press the 'Yes' or
'No' key and re-enter
your access code.
CALL ENGINEER
PIR HALL
System has been
programmed for Engineer
Reset. Call alarm company
to reset system.
Note 3
An anti-tamper circuit
which protects the system
caused the alarm
condition. Call the
engineer to investigate
cause before resetting.
Note 4
A fault has occurred within
the control panel. Call the
engineer to
investigate cause before re-
setting system.
8
A A
FTER LARM
Enter the premises via
the prescribed entry
route
Entry tone starts
Key-in your Access
Code at the nearest
keypad
ENTER CODE
****
Display will show
description of first circuit
violated e.g., PIR HALL
RESET REQUIRED
or
PIR HALL
Alternates between
ALARM
PIR HALL
or
TAMPER
PIR HALL
or
SYSTEM FAULT
Assuming the cause has
been established, reset the
system using a valid access
code
C
ONDITION
Note 2
A normal alarm zone has
caused the alarm
condition.
SYSTEM FAULT