3 Washer Bolts, 6 x 20 mm
Washer Bolt 6 x 16 mm
4 Hose clamps
© 2015 American Honda Motor Co., Inc. – All Rights Reserved.
ATF COOLER KIT
REQUIRED SPECIAL TOOLS
10 mm socket
8 mm Hex socket
T30 Torx socket
The following tools are available through the Honda Tool
and Equipment Program. On the iN, click on: Service >
Service Bay > Tool and Equipment Program, then enter
the number under "Search." Or, call 888-424-6857.
• Trim Tool Set (T/N SOJATP2014)
• Clip Pliers (T/N 07AAC-001A100)
Client Information: The information in this installation
instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
NOTE: Allow the engine and transmission to cool down
before installing the ATF cooler.
(LX, EX and EX-L)
Remove the front bulkhead cover, the resonator, and
the intake air guide.
FRONT BULKHEAD COVER
1 of 3