Attach The Speaker To The Display; Remove The Stand - Sanyo AVL-279 Instruction Manual

Attach the Speaker
System to the Display
The appearance of the unit
may differ from the actual
one.
To deattach the speaker,
perform the steps in reverse
order.
If applicable:
Removing the Stand
for Wall-Mounting
Cautions:
1. Carefully handle the unit during setup and consult authorized service
personnel to ensure successful installation.
2. Before performing work spread cushioning over the base area to lay the
Display on. This will prevent it from being damaged.
3. Disconnect the AC power cord firstly.
Screw the Speaker and the Fixed
board to the unit using the supplied
screws and tighten securely, then
install the two Connecting covers as
the diagram illustrates.
Connect only the supplied speaker
audio cables between the speaker
terminals on the unit and the
speaker matching polarity
according to the terminals' color.
Cautions:
1. Carefully handle the unit during setup and consult authorized service
personnel to ensure successful installation.
2. Before performing work spread cushioning over the base area to lay the
Display on. This will prevent it from being damaged.
3. Disconnect the AC power cord firstly.
1
Rear cover
Take off the rear cover.
Do not remove the stand and
speaker from the Display unless
using an optional bracket to
mount it.
The appearance of the unit may
differ from the actual one.
To attach the stand, perform the
steps in reverse order.
Introducing the TV
Fixed board
Screws
Connecting cover
Connecting cover
2
Screws
Loosen the screws on the
Stand to remove the Stand.
3
Replace the rear cover
Fixed board
Screws
Stand
8