LaMotte WaterLink Spin Touch DW Quick Start Manual

WaterLink
QUICK START GUIDE

BEFORE FIRST USE

¬ Fully charge battery.
¬ Ensure your Spin Touch has the latest fi rmware:
For fi rmware updates contact technical support at 800-344-
3100 ext. 3 or support@lamotte.com.
TESTING
1. Press and hold until the
meter turns on.
2. Tap . Select a Water Source ele l l l l l l
type. Tap
3. Tap . Select a disk series
(f (found on disk packaging). Tap f f f f f f o
to confi rm.
NOTE: Disk Series are limited
by Water Source Type
selection.
4. Remove a disk from the
packaging.
5. Use the syringe (1189) to fi ll
the disk with the water sample.
6. Insert the disk. Cover the disk
with the Universal Disk Cover.
Close the lid.
DOS & DON'TS
¬ The change Hardness test result units (gpg, ppm) go to
> Other Settings > Hardness Units
¬ Do not touch top or bottom of disk. Handle disk on edge.
¬ Hold syringe vertically when fi lling disks.
¬ Fill the disk on a dark surface to more easily see the sample water.
¬ Do not fi ll disk while in the meter. Fill disk on clean, dry surface.
¬ The disk should not contain any large air bubbles. Air bubbles will
result in erroneous results.
¬ Always use the disk cover.
¬ Only the Universal Disk Cover (Code 1719) can be used with the
®
WaterLink Spin Touch
¬ Empty syringe of previous sample before fi lling with next sample.
¬ Remove fi lled disk from meter after testing. Do not travel with fi lled
disks in meter. They may leak.
support@lamotte.com | 410-778-3100 | 800-344-3100 | www.lamotte.com
Sp
to confi rm.
™
.
n Touch
7. Tap to start test. Tap
to stop the test.
8. The results will be displayed.
9. Choose an option. se e e e e e e e
- Tap to return to the Test
Screen.
- Tap the highlighted
save the test results to the
test log if Auto Save is not
enabled.
- Tap the hightlighted
to send the results to the
enabled Mobile Bluetooth
Printer.
10. Press and hold
seconds to turn the meter off .
DW
to
for 2