Light-Measuring Mode Setting - Sanyo VPC-MZ3 Instruction Manual

LIGHT-MEASURING MODE SETTING

You can select from 3 types of light-measuring modes.
Multi-section light-measuring : Light is measured by sampling from
Center-weighted light-measuring : Light is measured from the entire
Spot light-measuring : You can compose the picture and capture the image
1
Display a Shooting Setting Screen
(see page 39).
2
Select a light-measuring mode from
the light-measuring mode (EXP
MEASURE) menu.
V: Multi-section light-measuring
X: Center light-measuring
W: Spot light-measuring
3
Press the SET button
œ This completes the light-measuring
mode setting.
œ When spot light-measuring is
selected, the light-measuring spot
mark K appears in the center of
the LCD monitor.
HINT
Shooting with the spot light-measuring mode
œ Point the camera so that the light-measuring spot mark is centered on the
specific spot you wish to use to measure the light, and press the shutter
release button halfway. The light at the spot mark will be measured.
Keeping the shutter release button depressed halfway, compose the
picture and press the shutter release button all the way down to capture the
image.
multiple areas of the entire shooting screen.
shooting screen, but gives more
importance to the values near the
center.
after first measuring the light only at the center spot
of the LCD monitor.
B
EXP MEASURE
MULTI
EXPERT
3.1
1/50
Light-measuring spot mark
14
14
106
English