Computer Input; Input Source Selection - Sanyo PLC-XU70 Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Choose either Computer 1 or Computer 2 by pressing the
INPUT button on the top control or press the COMPUTER
button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2
Press the Point
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
✔
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out. (p44)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can accept only
RGB signal.
buttons to move the red
7 8
ed buttons to move the red arrow
TOP CONTROL INPUT button
INPUT button
POWER WARNING LA
REMOTE CONTROL
COMPUTER button
COMPUTER button
✳ See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red
arrow) to Computer 1
and press the SELECT
button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer 1
✳
Computer 2
Video
Computer 1
✳
Computer 2
25