Basic Set-Up And Connections - Sanyo DS27930, DS32424 Owner's Manual

Basic Set-up and Connections

QuickTips
The TV will auto-
■
matically select the
correct Antenna
mode for the type
of RF signal you
connect.
TV will switch off
■
automatically after
15 minutes if there is
no signal reception
(cable out or station
not broadcasting).
Exception—When
the Video mode is
selected, the TV will
not automatically
switch off when
signal reception
has stopped for 15
minutes.
If you move the TV
■
to a new location,
press the RESET key
twice after connect-
ing the signal and
turning on the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
4
Basic Set-up & Connections
Initial Set-up
1. Install batteries in remote control, see page 7.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions.
Connecting Cable Service, RF Antenna, or Satellite Dish Receiver to
TV
Cable Service
Note: If you do not have a VCR
connect signal directly
to TV 75 ohm jack.
S-Video Input Terminal
To enhance video detail use the S-Video AV1 and
AV2 jacks instead of the Video jacks, if available
on your external equipment.
(S-Video connections will override con-
nections to the AV input jacks.) (See page 5.)
Audio Output Jacks
Connect external audio equipment here.
(See page 6.)
480i Component Video In Jacks
(Component 3, Y, Pb, Pr)
Connect video equipment here.
(See page 6.)
Operational Tip for No Signal Connection:
If the TV is used as a monitor only, with a DVD player or some other type of external equip-
ment, and no cable or antenna signal is available, the following setup is necessary:
Your TV is designed to automatically search for available channels. Therefore, the initial
start up requires that you press the MENU key, enabling the TV to automatically go through
the channel search process before you can operate the TV. After the initial channel search is
completed, you must press the MENU key again to complete the channel search process (may
take several minutes).
After the channel search process is complete (2 searches), you can press the INPUT key on
the remote control to use the TV as a monitor.
Satellite Receiver
CATV IN
CH3
CH4
VIDEO L- AUDIO -R IN FROM
OUT TO TV S-VIDEO
SAT.
VIDEO L- AUDIO -R
VCR Back
IN
FROM ANT.
OUT
OUT TO TV
VIDEO AUDIO INPUT
COMPONENT
S-VIDEO
Y
AUDIO
OUTPUT
(MONO)
P
L L b
AUDIO
R R P
r
Audio/Video Input Jacks (AV1 / AV2)
Connect video equipment here (see pages 5 ~ 6).
Note: S-Video connections override the AV1 and
AV2 video connections.
RF Antenna
TV Back
AV2 AV1
UHF/VHF/CATV
VIDEO
75Ω
(MONO)
L L
AUDIO
R R