Sanyo CAS-D6325 Instruction Manual page 45

USING
THE ANSWERING SYSTEM
To operate from a remote location, use any touch-tone telephone, and follow these steps:
1.
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after
about ten rings and sounds a series of beeps.
2.
During the greeting (or the beeps if answering system is off), press 0 and enter your security code/PIN within two
seconds ( see Setting a Security Code or Personal Identification Number (PIN) on page E39 ).
3.
The answering system announces the current time and the number of messages stored in memory.
You hear "To play incoming messages, press zero-two. For help, press one-zero" followed by a beep.
4.
Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the first
command, you have two seconds to enter each command.
Remote Commands
Command
0 then 1 Repeat a message*
0 then 2 Play incoming messages
0 then 3 Skip a message
* If you press 0 then 1 in the first four seconds of a message, the system skips to the previous message.
If you press 0 then 1 after the first four seconds of a message, the system repeats the current message.
5.
When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode. Enter
another command from the chart within fifteen seconds.
6.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.
UC590EH.indd E43 UC590EH.indd E43
Function Command
0 then 4
0 then 5
0 then 6
Function Command
Delete a message 0 then 9
Stop operation 1 then 0
Answering system on
E43
Function
Answering system off
Help
8/19/2008 11:39:11 AM 8/19/2008 11:39:11 AM