Advertisement
Step 7
BO18
1
Attach weather stripping 3/16x2
(5 mm x 5,1 cm) to one end, on the
inside of rear roof channel. Continue
to stick weather stripping to rear roof
channel. Peel paper backing.
2
Fasten top of right roof panel us-
ing two #10-32x7/16" (11 mm) bolts
and square nuts into bottom ange,
on rear roof channel. Fasten bottom
of panel using two #10-32x3/4" (19
mm) bolts into front facia. Pass bolt
through panel and tighten until snug.
Do not over-tighten.
IMPORTANT
2x4's (38 mm x 89 mm) centered
under roof panel will help you align
the holes
3
Lock a main roof panel and right
roof panel together and slide into
the rear roof channel. We recom-
mend that the two mating edges are
lubricated with a liquid detergent
when sliding into the channel. Use a
2x4 (38 mm x 89 mm) and hammer
to lightly tap roof panels into place.
Be sure entire rib on roof panels are
interlocked together.
4
Fasten top and bottom of panel in
the same manner. Fasten overlap-
ping ribs to rear roof channel using
a #10Ax3/8" (10 mm) screw.
5
Continue installing the remaining
two main and the left roof panel as
before.
NOTE
Leave out outer rib screw for trim
piece in the next assembly step
on the right and left roof panel
Parts Needed For
Roof Assembly
To square unit, measure diagonally. Make
sure both diagonal measurements are the
same. These measurements are taken from
opposite ends of facia and rear wall chan-
nel. Measure from the top outside edge of
facia to the top outside edge of the rear wall
channel. If diagonal dimensions are not the
same, adjust assembled facia section left to
right until the diagonals are equal.
Diagonal Measurement
Rear Roof Channel Assembly
Concrete Slab
18
9662 Right Roof Panel (one)
9653 Main Roof Panel (three)
9663 Left Roof Panel (one)
66644 Weather Seal
3/16x 2 (5 mm x 5,1 cm) (one)
Rear Roof Channel Assembly
3/16 x 2 (5 mm x 5,1 cm)
Weather Seal
Level
STEP
1
Advertisement
