Advertisement
Step 4
BO14
Get help holding post in place while
attaching the roof channel.
1
Position a roof channel, with small
hole 1 1/8" (2,9 cm) from end at left
post, and fasten to channel brace using
four #10-32x 7/16" (11 mm) bolts and
square nuts. Fasten other end to the
top end of the left post, noting location
of lock seam, using two #10-32x7/16"
(11 mm) bolts and square nuts, and
two #10Ax3/8" (10 mm) screws.
2
Fasten a front roof channel, with
most holes in ange on top, to the front
of left post, using the same fasteners,
with opposite end overlapping right
post, fasten as before. Brace center
of unit with 2x4's (38 mm x 89 mm)
as shown.
3
Repeat procedure with next roof
channel, as done in Step 1 to right
post and channel brace.
Parts Needed For
Roof Channel
Assembly
1 1/8"
9656
(2,9 cm)
#10-32x7/16"
(11 mm) Bolt
#10Ax3/8"
(10 mm) Screw
1 1/8"
(2,9 cm)
14
9656 Roof Channel (two)
Post Assemblies (two)
9733 Front Roof Channel (one)
STEP
1
Lock Seam
#10-32 Square Nut
Most Holes in Flange on Top
STEP
2
9733
9661 Left Post
Advertisement
