Electrical Connection; Cleaning Your Water Cooler; Storing Your Water Cooler; Appliance Intended Use - Aqua To Go Fresco Manual

ELECTRICAL CONNECTION

 Plug the appliance into an exclusive, properly installed, grounded wall outlet. Do not under
any circumstances alter this power plug.
 This appliance requires a standard 220-240-volt, 50Hz electrical outlet with three-prong ground.
 The cord should be secured behind the appliance and not left exposed or dangling as this might
cause accidental injury.
 Do not use an adapter plug or power board with this appliance.
 Do not use an extension cord with this appliance. If the power cord is too short, have a
qualified electrician install an outlet near the appliance.

CLEANING YOUR WATER COOLER

We suggest you give your cooler a general clean at least every 2 months or earlier if you experience a bad taste
in the water. In between general cleans we recommend that you remove and clean the spike disc and water
tank with standard dishwashing detergent.
General cleaning warning
DO NOT immerse the cooler in water. Do not hose the cooler. To prevent damage to the plastic parts, avoid
abrasive cleaning aids such as steel wool. Before cleaning always unplug the cooler from the power socket and
move to a water safe area in case you splash or water leaks. The top cover with spike, drip tray, and the cooler
plastic casing can be cleaned in warm water with any non-abrasive household cleaner, such as a mild
dishwashing liquid. Do not use bleach. Once a month inspect the plastic grill vents located on the back of the
dispenser. When turned off, remove any accumulation of dust.
To clean the stainless steel cooling tank and taps:
 Unplug the water cooler from the power and turn off both power switches on the rear of the cooler.
 Remove bottle and dispense all remaining water from both taps.
 Move water cooler to an area outside where when water flows no damage is caused.
 Unscrew the rear drain cap, which is located near the bottom of the water cooler casing. Be careful as
the water will flow out and may make a mess.
 Leave the unit outside, and unplugged from the power, whilst you do the rest of the below steps.
 Hold onto the spike disk, twist it anti-clockwise and lift to reveal the water tank.
 Put tap water into the tank and flush through a couple of litres through the unit, which will come out the
rear drain cap and the rest you can dispense from the taps.
 Now screw back on the rear drain cap.
 Mix 30ML (1 & 1/2 caps) of Milton anti-bacterial cleaning solution (available from most
supermarkets) into 1 litre of hot water and pour this into the water tank until it is full. At this time
please also clean the sides of the water tank. Now let the cooler sit over night with this cleaning
solution in it.
Alternatively – Fill the tank with hot tap water and mix in two tablespoons of baking soda, leave it
overnight.
 Next morning unscrew the rear drain cap and flush through at least 2 litres of tap water, dispensing the
rest of the water through the taps.
 Put the bottom drain cap back on.
 Put the water cooler back inside in the desired location and put a bottle back on the water cooler.
 Very Important – Now dispense a cup of water from red hot tap, before you turn power on.
Only then plug it back into the power and turn the rear power switch on

STORING YOUR WATER COOLER

If your water cooler will not be used for a long period of time,
 Unplug the power cord from the electrical outlet.
 Drain the water through the drain caps underneath the water cooler base (be careful with
the hot water and once fully drained do not forget to fix it back securely) and then store
Page 8 of 11