Pre-Rinse Instructions; Fitting The Aqua To Go Premium Spring Water Bottle; Cold Water Control; Hot Water Control - Aqua To Go Fresco Manual

PRE RINSE INSTRUCTIONS
Your water cooler has been pre-cleaned but the reservoir and water lines should be flushed with fresh tap or
spring water.

Keep the cooler unplugged from the power socket.

Gently twist the water intake spike anticlockwise and lift off the top cover.

Slowly pour into the water tank about 2 litres of fresh water. Let water settle for about two minutes.

Press the hot water safety tap (red) until water comes out (may take up to 30 seconds), then stop.

Unplug the cooler from the electrical outlet. Proceed to drain the water by using the cold tap (blue)
until no more water remains. To facilitate this procedure, use a large container/bucket.

To put top cover back on, place into the slots, hold the spike and gently twist clockwise. Lift spike
gently upwards to test that the top cover is now properly secured on the cooler.
Note: Your water dispenser has already been cleaned and sanitised, but in the unlikely case that there is a
slight taste issue, mix two tablespoons of baking soda into a small bucket of warm/hot fresh tap water, fill
the water tank with this, leave it in the cooler over night, and then repeat the (above) pre rinse instructions.
FITTING AN AQUA TO GO PREMIUM SPRING WATER BOTTLE

Your cooler should be first be placed in its appropriate position.

Read any instructions on the bottle and bottle cap.

Use a clean cloth to wipe over the cap and shoulder of the bottle.

Gently place and then lower the bottle onto the water intake spike.

Allow the water to stand for about 2 minutes.

Wipe off any water which may have splashed on the cooler casing. Do not let water run inside the
casing.

Dispense a cup of water from the red hot tap (it may initially take up to 30 seconds to flow).

Plug in the power cord. Now turn on the power outlet switch and the two rear switches on the cooler.

Allow up to 1hr to reach optimal temperature. Press down on each water tap to ensure water flows.
Red tap – hot water. Blue tap – cold water.

Store all spare bottles in a cool place, out of direct sunlight.

Now you are ready to use your water cooler – Enjoy!

HOT WATER CONTROL

Dispense one cup of water from the hot tap prior to turning on the red heating switch on the rear of the cooler
(never run your cooler dry). The red (hot) indicator will then be lit and the heating process will start. When
the water reaches the appropriate temperature the red (hot) indicator will turn off. When the temperature
goes down to approx 80C, the red indicator will glow again and another heating process will start. To save
electricity and extend the life of your water cooler you can turn off the hot power switch if you don't need
hot water for any lengthy period of time, as it will heat quickly once turned on again. It's best though to leave
the cold power switch on because the cooling system takes much longer to reach its optimal temperature.

COLD WATER CONTROL

To turn on the cooling operation turn on power outlet and the green switch on the back of the cooler. The
green (cold) indicator will stay lit whilst the cooling process is on. Once the water reaches the appropriate
temperature the green (cold) indicator will turn off and will remain unlit until the cooler starts the cooling
process again.

TEMPERATURE CONTROL

Water coolers are designed to work in non humid environments, in rooms with temperatures no greater than
25C. A harsh environment will have a significant impact on the performance of this model. In appropriate
room conditions the thermostat is set to deliver water generally in the range of 6C to 10C for cold water.
Water temperature will depend upon usage, room temperature, humidity and when the cooling system last
cycled/activated. Accurate temperatures are measured from the water flow and not from within the container
that the water is dispensed.
Page 7 of 11