Getting Started (Required Initial Setup) - Sanyo HT27547 Owner's Manual

GETTING STARTED (REQUIRED INITIAL SETUP)

1
Install batteries in remote control (2AA, not included).
PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.
Remove the batteries if the Remote Control will not be used for
a month or more. Discharged batteries may leak and damage
the unit.
2
Connect Signal to the DTV's Digital 75 ohm Antenna Input terminal.
Digital (DTV) RF Antenna Connection
Connect an RF an-tenna to the Digital Antenna
In terminal.
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels using
the "Digital Cable Search" menu option.
DTV BACK
OR
3. The output from a VCR or cable box.
Digital signals from a Set-top (STB) Box should be
received through the Component jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
Match the "+" and
"–" signs on the bat-
teries with
inside the
control.
RF ANTENNA
(CONTINUED ON NEXT PAGE.)
marks
remote
13