Makita DUR365U Instruction Manual page 13

4
1. Nylon cutting head 2. Metal guard 3. Receive
washer 4. Hex wrench 5. Tighten
5
4
1. Plastic blade 2. Metal guard 3. Receive washer
4. Hex wrench 5. Tighten
Insert the hex wrench through the hole on the motor
housing and rotate the receive washer until it is locked
with the hex wrench. Place the nylon cutting head /
plastic blade onto the threaded spindle directly and
tighten it by turning it counterclockwise. Remove the
hex wrench.
To remove the nylon cutting head / plastic blade, turn
it clockwise while holding the receive washer with the
hex wrench.
Hex wrench storage
1. Hex wrench
When not in use, store the hex wrench as shown in the
5
1
1
OPERATION
1
Correct handling of tool
2
WARNING:
3 • Be extremely careful to maintain control of
the tool at all times. Do not allow the tool to
work vicinity. Failure to keep control of the tool
and the operator.
Correct posture
WARNING:
•
tion the tool on your right-hand side so that
the shaft of the left handle is always in front
of your body. Correct positioning of the tool
2
allows for maximum control and will reduce
3
kickback.
your right side so that the shaft of the left handle is
always ahead of you.
Attachment of shoulder harness
1
2
1. Buckle 2. Hook
Wear the shoulder harness on your left shoulder. Make
sure that the buckle cannot be taken off with pulling it
off. Hang the tool as shown.
13 ENGLISH
-