Table of Contents
Advertisement
Installation & Operation Guide
Step 3. Disconnect all wiring and completely remove module.
Step 4. At new module, set DIP switches to same address as previous module or use module position 1 - 3 - 5 (as
indicated in Figure 9).
WARNING! The address must exactly match the address of the dimmer being replaced. Failure to re-address the
new dimmer will result in improper operation.
Step 5. Connect all wiring (dimmer module communications, Neutral A, Neutral B, Line A In, Line B In, Load A
Out, and Load B Out connections) to new module.
Step 6. Insert new module into eS21 LED Raceway and replace four mounting screws.
Step 7. Power up and test operation.
2 4
OPERATION AND PROGRAMMING
eS21 LED Raceway
Advertisement
Table of Contents
