Led Modules - Philips eS21 Installation & Operation Manual

Installation & Operation Guide

LED Modules

Each eS21 LED Raceway LED Module contains four channels of LED luminaire control. The module is a LED
power supply that is designed to deliver power and data (through its four low-voltage connectors) to power and
control any Selecon PL Wash luminaire or Color Kinetics Blast fixtures. See Figure 2 for details.
LED Module - Focus Buttons
The Focus Buttons can be used to quickly operate or test the fixtures as follows:
• Tap - toggles fixtures from OFF to ON (or ON to OFF) on all channels if DMX512 signal is not present.
• Hold - turns fixture ON to 100% (all channels) if DMX512 signal is present. Returns to DMX level when button is
released.
LED Modules - LED Indicators
The two LEDs associated with each channel report various operating conditions. The Red LED turns on for
approximately 4 seconds on power-up, and after that the indications are as follows:
LED Modules - Data / Power Connections
Below is a diagram on how to wire to the connectors in the LED Module 4-pin connectors.
2
1
WARNING! This connector (on LED Modules) is for use with specified LED fixtures only. Use or connection of
any other device will damage module and void the eS21 LED Raceway's warranty.
1 0
DIMMER SYSTEM FUNDAMENTALS
Figure 2: LED Module Focus Buttons / LED Indicators
Red LED
On
Off
LED Module 4-Pin Connector Pinout:
Pin
3
1
4
2
3
4
Focus Button / Status LED Indicators
(one set for each channel)
Green LED
Off No Communications with Head-End Processor
On Module is set to 100% by Focus button
Only for use with:
Signal
+24 Volts DC
Not Used
Data
Ground
eS21 LED Raceway
Condition
Philips Philips
Color Kinetics Selecon
iW Blast PLW-WW
TR Blast PLW-RGB
TRX Blast PLW-RGBAW