Table of Contents
Advertisement
Installation & Operation Guide
LCD Menu Structure (continued)
Continued from previous page
SYSTEM CONFIG (Sets System Options, user-selectable options)
Sub Menu
DMX Hold (hh:mm) (in hours :
minutes)
Power-up Preset
Power-up Hold
SELECT PRESET (Selects Recorded Strip Presets)
Sub Menu
Preset
EDIT PRESETS
Sub Menu
Mod/Port
Preset
Level (%)
Dimmer Set
MENU CONFIG
Sub Menu
Set Splash Display
Strip ID
Backlight On (min) (in minutes
Display Contrast
Set New Password
2 0
OPERATION AND PROGRAMMING
Options
None / 0:01 / 0:05 / 0:10 / 0:15 / 1:00 /
2:00 / 4:00 / 12:00 / 24:00
None / 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
Forever / 0:01 / 0:05 / 0:10 / 0:15 /
1:00 / 2:00 / 4:00 / 12:00 / 24:00
Options
1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
Options
Not Applicable
1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
0 to 100% (in 1% increments)
One / All / Capture All
Options
Philips
Strip DMX
Strip ID
DMX ADDR
#
#
#
#
#
Always (always on) / 0 to 60 minutes
(in 1 minute increments)
0 to 100% (in 1% increments)
#
#
#
#
eS21 LED Raceway
Comments
Sets the amount of time the eS21
LED Strip will keep and adhere to the
last DMX512 levels
Sets what preset the output device go
to when LED strip is initially powered
Sets the amount of time the output
devices will go and stay at the preset
level (if set) when the LED strip is
initially powered.
Comments
Selects the recorded preset
Comments
Displays Module, Port and DMX
Address
Selects the preset to be programmed
Selects the preset level of the
dimmers, relays or PL Wash (each
dimmer is individually programmable)
Allows users to set preset to one or all
dimmers or luminaires (at the same
time) or Capture (snapshot) a look
from DMX
Comments
Sets the display to Splash Screen 1
after a power up or time out
Sets the display to Splash Screen 2
after a power up or time out
Sets the display to Splash Screen 3
after a power up or time out
Sets the display to Splash Screen 4
after a power up or time out
Sets User ID. Each "#" can be set
from A to Z, 0 to 9, dash ("-") or
underscore ("_")to establish a five-
digit strip ID.
Sets the amount of time the Head-
End Processor LCD Display backlight
is on after last button press
Allows user to set the contrast level of
the LCD Display
Each "#" can be set from 0 to 9
(numeric only) to establish a four-digit
password. For more information, see
"LCD Display Passwords and
Security"
below.
Advertisement
Table of Contents
