Table of Contents
Advertisement
eS21 LED Raceway
LED Modules - LED Luminaire Connection, Setup, and Addressing
Connection and setup of a LED luminaire to a LED Module:
Step 1. Connect LED luminaire to LED module output connector.
Note: LED modules will be displayed on LCD Menu as Module Number and Port Number. If the LED luminaire is
connected to Module 2, Port 3 it will be displayed on the LCD Menu as "2/3". See
Module status information shown, no user-selectable options)" on page
Step 2. Set luminaire type in one of two ways:
a. Using the LED Type menu option, Discover and the strip will determine the luminaire type as described
in
"MOD/PORT CONFIG (LED Module configuration, user-selectable options)" on page
b. Using the LED Type menu options, WW, RGB, or RGBAW and set luminaire type directly as described
in
"MOD/PORT CONFIG (LED Module configuration, user-selectable options)" on page
Step 3. As described in
page
19, using LCD Menu, set DMX Address for connected luminaire.
Note: DMX Address resides at the LED module's port, not the LED luminaire.
Relay Modules
Each eS21 LED Raceway Relay Module contains two independent relays. See Figure 3 for more information.
Relay A Focus Button /
LED Indicator
Relay Module - Focus Buttons
The Focus Buttons can be used to quickly to operate or test the module as follows:
• The relay module focus button is either an ON of OFF button.
• Tapping the focus button will turn the circuit on, tapping it again will turn the circuit off.
Relay Modules - LED Indicators
The two LEDs associated with each relay report various operating conditions. The Red LED turns on for
approximately 4 seconds on power-up, and after that the indications are as follows:
"MOD/PORT DMX ADDR (Sets DMX Address to Each Port, user-selectable options)" on
Figure 3: Relay Module Focus Buttons / LED Indicators
Red LED
Off
Off
On
Flashing
17.
Green LED
Off
On
Focus Mode (controlled at relay module)
Off
Flashing
Installation & Operation Guide
"MOD/PORT STATUS (LED
19. OR;
19.
Relay B Focus Button /
LED Indicator
Condition
Normal
Communication Error
Miswire to Line
eS21 LED Raceway Modules
11
Advertisement
Table of Contents
