Table of Contents
Advertisement
Installation & Operation Guide
LCD Menu Structure (continued)
Continued from previous page
MOD/PORT CONFIG (Dimmer Module configuration, user-selectable options)
Sub Menu
Mod/Port
Mode
Non Dim %
Voltage at Full (VAC)
Transition (uS)
Dimmer Curve
High Trim
Low Trim
Always On
Preheat
MOD/PORT CONFIG (Relay Module configuration, user-selectable options)
Sub Menu
Mod/Port
Non Dim %
Continued next page
1 8
OPERATION AND PROGRAMMING
Options
Not Applicable
RPC (Reverse Phase Control)
FPC (Forward Phase Control)
Non-Dim
LED - RPC (Reverse Phase Control)
LED - FPC (Forward Phase Control)
0 to 100%
200 / 220 / 230 / 240 VAC
400 / Auto
Linear / Square Law / Invert / Slow
Bottom / Fast Bottom / Fast Top / Full
at 1 / Out at 100 / Preheat 5% /
Preheat 10% / Hot Patch / Adv Mark
10 (fluorescent ballasts)
1 to 100%
0 to 99%
Yes or No
Yes / No
Options
Not Applicable
0 to 100%
eS21 LED Raceway
Comments
Displays Module, Port and DMX
Address
Sets dimmer operation to reverse
phase control
Sets dimmer operation to forward
phase control
Sets dimmer operation to non-dim
operation (On or Off operation only -
no dimming)
Sets dimmer for line voltage LED
fixtures that require locked reverse
phase control dimming.
When dimmer is set to Non-Dim, this
option sets the dimmer's threshold
level (selection 0 to 100%). Levels
below the set percentage will turn the
dimmer off and levels equal to or
above the set percentage will turn the
dimmer on. *WARNING: Setting a
dimmer to act as a Non-Dim device
is NOT recommended to control
loads that require a solid-state
relay. Doing so could damage the
device and/or dimmer.
Sets dimmer operational voltage.
NOTE: Using a lower voltage than
lamp specification can prolong lamp
life.
Options available (in both FPC and
RPC) are either 400 (set) or AUTO
(automatically and continuously
adjusts between 400 or 1000 uS)
Sets dimmer curve (dimming
operation) for each dimmer in the
eS21 LED Strip
Sets the top end of the dimmer
operational limit
Sets the low end of the dimmer
operational limit
If set to Yes, then the dimmer stays on
to the Low Trim setting.
Allows dimmer to be set to preheat
mode. Normally preheat mode is used
to "speed up" large wattage lamps so
they behave more like smaller ones
Comments
Displays Module, Port and DMX
Address
This option sets the relay's threshold
level (selection 0 to 100%). Levels
below the set percentage will turn the
relay off and levels equal to or above
the set percentage will turn the relay
on.
Advertisement
Table of Contents
