Overview; Connect To Server - BITMAIN C1 Manual

1 Overview

Bitmain's first Liquid Cooled Server – the C1: This manual is only for C1's set up, Cooling Kit is
direct supported by the third-party recommended.
Note:
1. You must prepare your own ATX Power Supply. There are 4 PCI-e connectors for +12V DC
input and all are required.
2. Cooling kit is not included in C1, please read the instruction at www.bitmaintech.com to
buy them.

2 Connect to Server

Step 1. Connect your server and PC via network cable.
Step 2. Enter server's default IP address: 192.168.1.99 into your web browser, then login server
management interface, both of username and password is 'root' by default.
Step 3. Modify the IP address of the server. Click "NetworkSettings" to modify the IP address
as shown in below screenshot. Choose 'Save and Apply' after modifying it.
*** If you decide to change the server's IP address, Please Write It Down & DO NOT FORGET
it. If you forget the IP address, you will not be able to access server again. ***
Page3 / 9
C1 Manual
Last updated: 10/30/2014
Page 3 of 9