Suitable Cable Types
DCell/DSC CAN Bus Cable
The Cable requirements are dependent on the bit rate of the CAN bus and the required distances. Special care is
required for bit rates of over 500Kbps not only in the choice of cable used but how the bus wiring is organised ie the
requirement for very small stub lengths for high bit rates.
For low bit rates the requirements can be specified as follows
A suitable type is BICC Brand-Rex BE56723 (also equivalent to Belden type 8723).
In the UK, this is available from Farnell, part number 118-2117.
For bit rates above 500Kbps the following is recommended
Belden B3084A
Belden B8132
Indication Of Maximum Bus Length
The following indication is for the communications lines only. It does not include the power lines, which may limit
the length further due to voltage drops and initial power supply level.
Mantracourt Electronics Limited DCell & DSC MantraCAN User Manual
Bit Rate
Maximum Line
length
1Mbits/s
800Kbits/s
500Kbits/s
100m
250Kbits/s
250m
125Kbits/s
500m
50Kbits/s
1000m
20Kbits/s
2500m
25m
50m
64