Frequently Asked Questions - Geo Minim+ Quick Start Manual

Frequently asked questions

How do I set the tariff on my monitor?
In the settings menu select the TARIFF option. You can set
up to three tariffs and a standing charge. Use the and
a c
buttons to change the tariff value and button to save. You
¡
can set up to two different tariffs for different times of day:
these can be found on your energy bill or by speaking to
your energy provider.
How do I set my budget?
In the settings menu, select the BUDGET option. Enter your
monthly expenditure using the and buttons and
¡
a c
button to save.
How do I turn the backlight off?
In the settings menu, select the BACKLIGHT option. You can
select either ALWAYS ON or TIMED (by pressing the and
a c
buttons). If you select TIMED, you can set the time when you
would like the backlight to be on (DISP ON) and off (DISP OFF).
The signal strength indicator is not showing and
the speedometer does not show?
In some cases it may be necessary to move the display closer
to the transmitter. If this does not work, the transmitter and
display may need to be paired again. Please see below for
more information.
How do I change currency?
In the settings menu select the CURRENCY option. Use the
and buttons to change the currency value and button
¡
a c
to save. This will change the tariff and budget settings so
remember to check these afterwards.
How long is the transmitter battery life?
The battery life is up to two years. When the battery indicator
starts to flash replace the 3 X 1.5V AA Alkaline / LR6 batteries
in the transmitter.
My monitor is under or over reading?
Check the LED SENSOR setting in the menu to ensure it
matches the setting for your meter. Most meters provide
1000 pulses per kilowatt hour, but this is not always the case.
Use the and buttons to change the sensor value and
¡
a c
button to save.
How do I re-pair the transmitter to the display?
To enter pairing mode on the display, hold down the and
a c
buttons together for 3 seconds. Once at the next screen, hold
down the middle button for 3 seconds until the Display shows
"Pair?". The display is now ready to pair to the transmitter.
Remove the cover from your transmitter, then press and
hold the pair button (next to the red light) until you see a
red LED light. When you release the pair button the LED
flashes as the transmitter pairs with the display unit. Your
display should now read "Paired LED". Press any button to
return to the main screen.