Table of Contents
Advertisement
Function
With the control keys on the projector locked, you can prevent your projector
settings from being changed accidentally (by children, for example). When
the Panel Key Lock is on, no control keys on the projector and remote
control will operate except
To release panel key lock, press any key of the projector once to display the
Panel Key
panel key lock warning. With the warning being displayed, press
Lock
on the projector or remote control again. (Press and hold the key on the
projector for 3 seconds.).
Allows you to select a preferred control port: through the RS232/LAN port
Control Port
(CONTROL or LAN port on the projector), or the HDBaseT port (HDBaseT
Setting
input port on the projector).
This projector is equipped with network function. You can manage and
control the projector from a remote computer using a web browser when they
are properly connected to the same local area network.
• Wired LAN
Network
Settings
• PJLink Certification: Prevents unauthorized connection to the projector via
PJLink application. The default password is "admin". After selecting On, you
can change PJLink password.
• Change PJLink Password: Enter the current password. Press ,
select the digit and press ,
OK to confirm. Enter the new password and press OK to confirm.
• AMX Device Discovery: When this function is On, the projector can be
detected by AMX controller.
• MAC Address: Displays the mac address for this projector.
Keys on the remote control are still in use when panel key lock is enabled. If
you turn off the projector without disabling panel key lock, the projector will
still be in locked status the next time it is turned on.
• Status: Shows the connection status.
• DHCP: Select On if you are in a DHCP environment and IP Address,
Subnet Mask, Default Gateway, DNS Server settings will be
automatically retrieved. Select Off if you are in a non-DHCP environment
and make adjustments to below settings.
• IP Address
• Subnet Mask
• Default Gateway
• DNS Server
• Apply
If you forget the password, please use the password "projectorcontroller".
For details on controlling the projector from a remote computer, see
"Controlling the projector remotely through a web browser (e-Control®)" on
.
page 49
Description
.(POWER).
Only available when DHCP is set to Off. Use /
to select a column and use
value.
Enacts these settings.
to select from 0-9, A-Z, a-z or symbols. Press
Right/
/
to adjust the
to
Menu operation
47
Advertisement
Table of Contents
