Panduit FWME4 Installation Instructions

© Panduit Corp. 2010
FWME8
Contents:
Parts included with all enclosures:
1 - ENCLOSURE
2 - CABLE ENTRY GROMMETS
2 - STRAIN RELIEF BRACKETS
4 - BLACK CABLE TIES
1 - FIBER CAUTION LABEL
Assembly Instructions:
1. Determine the cable entry location on the enclosure.
Remove the knockout by inserting a screwdriver into the
slot located in the center of the knockout and applying a
twisting motion from the inside of the enclosure twisting
out. Insert grommet following proper cutting diagram.
Apply Laser Warning Label and Caution Label on the
inside of the larger door in a clearly visible location.
Apply Port I.D. Label(s) on the inside of the small door
(as shown).
Laser Warning
Label
Fiber Caution Label
Enclosure
For Technical Support: www.panduit.com/resources/install_maintain.asp
Opticom Fiber Wall Mount Enclosure
INSTALLATION INSTRUCTIONS
FWME4
1 - LASER WARNING LABEL
1 - FWMEHKIT
3 - #10-32 HEX NUTS
2 - #10-32 x 3/8" SCREWS
1 - FLAT WASHER
Grommet
Part Numbers: FWME2, FWME4, FWME8
Additional parts included with
FWME4, FWME8 enclosures:
4 - BEVELED ENTRY CLIPS
2 - PORT I.D. LABELS
Cut the small
circle for 1" dia.
innerduct
Page 1 of 2
FWME2
Additional parts included with
FWME2 enclosures:
1 - BEVELED ENTRY CLIPS
1 - PORT I.D. LABELS
Cut the large
Cut the straight lines
circle for 1-1/2"
when not using any
dia. innerduct
innerduct
Port I.D. Label
FS010