14. INSTALLATION
• The appliance is for built-in use only.
• The fitted cabinet must not have a back
wall behind the appliance.
• Put the appliance far away from steam,
hot air and water splashes.
• If you transport the appliance in cold
weather, do not activate it immediately
after the installation. Let is stand in the
room temperature and absorb the heat.
14.1 Electrical installation
This appliance is supplied with a main ca-
ble and main plug.
1. Check if the dimensions of the furni-
ture meet the installation distances.
CAUTION!
Do not block the air vents. If you
do that, the appliance can over-
heat.
CAUTION!
Do not connect the appliance to
adapters or extension leads. This
can cause overloading and risk of
fire.
WARNING!
Only a qualified person must do
the electrical installation.
The manufacturer is not responsi-
ble if you do not follow the safety
precautions from the chapter
"Safety Information".
CAUTION!
Minimum installation height is 85
cm.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. Put the template on the bottom of
cabinet and mark the spots for
screws. Remove the template and fix
the bracket with the screws.
3. Install the appliance. Make sure the
bracket locks the back of the appli-
ance.
mm
380 + 2
560 + 8
340
18
=
=