Installation - HIRED-HAND SUPER-SAVER XL SS-225-XL-120 Owner's Manual

5.

Installation

5.1 Hanging The Heater
Mount heater with screw hooks and chains so that
back of heater is at least 12 inches (305 mm) from
ceiling and wall. Heater must be a minimum of 20
inches (500 mm) from floor, and located so livestock
and combustible materials are unable to come in
contact with heater or within 10 ft (3 meters) of hot air
discharge.
5.2 Directions For Leveling
Adjust cables or chains as required
to level the
carpenter's level to check that the
heater is level.
5.3 Installing Dual-Flare Duct
Fold Dual-Flare duct to shape as
shown in Fig. 1. Install Dual-Flare
duct to heater exhaust (Fig. 1) as
shown with sheet metal screws
provided. This provides a multi-
directional heat flow that may be set
by bending flaps.
5.4 Connecting the Gas Supply
For gas connection (Fig. 2) attach
regulator to the Hi-Pressure Line (A)
at outside of building.
flexible hose (B) to low pressure end
of regulator
coupling. See page 1 for LP, and
natural gas requirements.
Part No. 4801-3031 Rev.6-09
Chain Suspension
heater. Use a
Connect
with special brass
If frequent height adjustment is required, use
cables and pulleys. Main line cable would be
connected to a winch.
Fig. 1
Flare Duct
Fig. 2
Gas Regulator
B
Fig. 2
Flexible
hose
Page of
7 22
Cable Suspension
Adjust Flap To
Direct Heat Flow
A
High Pressure
Line
Super Saver XL-120 Heater
Attach Flare
Duct To
Heater With
Sheet Metal
Screws