Table Of Contents - HIRED-HAND SUPER-SAVER XL SS-225-XL-120 Owner's Manual

Table Of Contents

1. Specifications And Requirements..................4
2. Warnings And Cautions .................................5
3. Maintenance And Warranty ...........................6
4. Installation......................................................7
5. User Instructions............................................8
6. Outside Mount (Optional)...............................9
7. Component And Wiring Diagram .................10
8. Ladder Type Schematic Diagram ................11
9. Servicing Instructions...................................12
10. Pipe Sizing Guidelines.................................17
11. Parts & Assemblies......................................19
HEATER DIMENSIONS
WEIGHT
HEIGHT
WIDTH
DEPTH
Heater must be located a minimum of 12 inches (305 mm) from ceiling, a minimum of 12 inches (305 mm) from wall,
a minimum of 20 inches (305 mm) from ground, and positioned so that livestock are unable to come in contact with
heater or within 10 feet (3 meters) of hot air discharge. (See Figure 1 - Installation Instructions).
1. Specifications And Requirements
Model No.
SS-225-XL
Maximum 14 in. W.C. (34.8 mbar) and minimum 12.5 in. W.C. (31.1 mbar) inlet gas supply
LP/Propane
pressure acceptable at gas regulator connection. Burner manifold pressure 11 in. W. C. (27.4
Gas
mbar) at maximum input. Gas pressure should be checked by a certified gas technician while
heater is in operation.
Maximum 14 in. W.C. (34.8 mbar) and minimum 5 in. W.C. (12.5 mbar) inlet gas supply pressure
Natural
acceptable at gas regulator connection. Burner manifold pressure of 3.5 in. W. C. (8.7 mbar) at
Gas
maximum input. Gas pressure should be checked by a certified gas technician while heater is in
operation.
Refer to heater ratings plate for unit voltage, amperage, and frequency ratings.
Part No. 4801-3031 Rev.6-09
130 lb. (60 kg)
30 in. (76.2 cm)
24-1/2 in. (62.2 cm)
19-1/4 in. (48.9 cm)
MINIMUM CLEARANCES
Maximum Input
225,000 BTUH (65.9 kW)
Be Sure To Check Delivery
Locate packing slip and make sure
all of the listed parts are enclosed.
If not, call
Distributor immediately.
Adjustable Wrench
Pipe Glue
Install screw hooks with hammer or drill.
Page of
3 22
!
your Hired-Hand
Gas Leak Testing Solution
1/4" (7 mm)
Nut Driver
Ventilation
(air required to support combustion)
3
1000 CFM (1699 m
Super Saver XL-120 Heater
/hr)