HIRED-HAND Super Saver XL Conversion Instructions

HIRED-HAND Super Saver XL Conversion Instructions

Convert ss-225xl-ism-lp-120v-60hz (6601-2508) to ss-225xl-ism-lp-240v-50hz (6601-0508)

Advertisement

CAUTION! Be sure that heater is cool before touching internal surfaces. These surfaces remain hot
B
A
F
Flame
sensor
Hired-Hand, Inc. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-1000 • Fax 256-287-2000

CONVERSION INSTRUCTIONS

Convert SS-225XL-ISM-LP-120V-60Hz (6601-2508)
to SS-225XL-ISM-LP-240V-50Hz (6601-0508)
Super Saver
Warning!
Warning!
Disconnect All Electrical Power Sources To Heater.
enough to cause severe burns during and after operation.
Warning!
Warning!
Turn Off And Disconnect Gas Supply To Heater.
C
Screws are located
at bottom of housing
and output vent.
Ground wire
Sheet Part No. 4801-5080
tm
XL Heaters
P
Q
T
D
M
N
O
E
Blower
Wheel
Plate
Motor
Instructions continued on back

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Super Saver XL and is the answer not in the manual?

Questions and answers

Summary of Contents for HIRED-HAND Super Saver XL

  • Page 1: Conversion Instructions

    Flame Blower sensor Wheel Plate Motor Ground wire Instructions continued on back Hired-Hand, Inc. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-1000 • Fax 256-287-2000 Sheet Part No. 4801-5080...
  • Page 2 25. Remove old label from side of heater ( ). Apply new label ( ) to heater. 4501-2991 26. Conversion complete. Hired-Hand, Inc. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-1000 • Fax 256-287-2000 Sheet Part No. 4801-5080...

Table of Contents