BD Diesel Performance Flow-MAX V3 Installation Instructions Manual page 7

3 October 2016
6. Locate the two supplied T Bolt
band clamps; unthread the nut
(7/16" Socket) from each of
them. Spread the clamps apart
and insert them through boxed
cutouts.
With both clamps inserted, place
the pump into place and align the
inlet and outlet parallel to the
frame.
The inlet
towards the fuel tank.
Tighten the clamps around the
motor body,
aluminum pump head.
nuts to 80 in-lbs.
7. Insert the Filter fitting (1500311-M)
into the (IN) side of the pump and
the ORB fitting (1500311) into the
outlet of the pump. Do not over
tighten as they use an o-ring for
sealing.
NOTE: If installing a filter kit, skip this
step and refer to the Flomax Filter Kit
manual for the install procedure for the
water separator and fuel filter. Once
Filter install is complete; continue to
step 8.
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295
# 1050301D 1998.5-2002 Dodge Cummins FlowMAX Lift Pump Kit (I-00167)
should be pointed
rather than
Torque
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bd-power.com
the
FITTING
BD Engine Brake Inc.
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
- 7 -
FITTING