Operation With The Remote Control Unit; Automatic Operation - Sanyo CH0951 Technical & Service Manual

1. Automatic Operation

NOTE
NOTE
12
Operation with the Remote
Control Unit
1HR.
TIMER
STEP 2
FLAP
ON
SET
Check that the circuit breaker on the power panel is turned on and that the
operation selector of the indoor unit is in the ON position.
Once the mode is selected and the unit is preset by following the steps
below, you can have the air conditioner automatically bring the room to the
desired temperature simply by pressing the ON/OFF operation button.
STEP 1 Press the MODE selector to select
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation button again.
•
To change the temperature setting, press the temperature setting
buttons and change the setting to the desired temperature.
•
The temperature setting changes by two degrees each time one of the
TEMP. buttons is pressed.
SET TEMP.
ON
TEMP.
OFF
FAN SPEED MODE
STEP 1
OFF
NIGHT
CANCEL SETBACK
.
OI-202-14EG