Sanyo C0951 Technical & Service Manual page 67

MODE selector button
(COOL)
FLAP button
NOTE
FAN SPEED selector
button
1 HR. TIMER button
(1-hour off timer)
ACL button (All clear)
SET button
CANCEL button
ADDRESS switch
OI-330-09EG
Remote Control Unit (continued)
Use this button to select the DRY or COOL mode.
(DRY) : The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
To switch to the sweep function (
hold down the FLAP button. (Refer to Adjusting the Air Flow Direction
on page 18.)
: The air conditioner automatically decides the fan speed.
: High fan speed
: Medium fan speed
: Low fan speed
: When you press this button, regardless of whether the unit is
1HR.
operating or stopped, the unit operates for one hour and then
shuts down.
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
After using the TIMER ON button or TIMER OFF button to set the timer,
press this button to activate the new setting.
Press this button to cancel the current timer ON and OFF setting.
The address switch changes to prevent mixing of signals from remote
control units when two Sanyo air conditioners are installed next to
each other. Normally, the address switch is set to A. When switching
the address, the remote control unit must be changed to B. For more
information, please contact the dealer where you made the purchase.
) when in the manual ( ) mode,
9