Using The Remote Control Unit - Sanyo C0951 Technical & Service Manual

How to Install Batteries
NOTE
How to Use the Remote
Control Unit
Remote Control Unit
Installation Position
DO NOT
10

Using the Remote Control Unit

ACL button
Cover
The batteries last about six months, depending on how much you use
•
the remote control unit. Replace the batteries when the remote control
unit's display fails to light, or when the remote control cannot be used
to change the air conditioner's settings.
Use two fresh leak-proof type-AAA alkaline batteries.
•
In replacing batteries, follow the instructions as mentioned in the
•
sub-section ''How to Install Batteries''.
If you do not use the remote control unit more than 1 month, take out
•
the batteries.
When using the remote control unit, always point the unit's transmitter
head directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Remote control
unit
The remote control unit may be operated either from a non-fixed position
or from a wall-mounted position. To ensure that the air conditioner operates
correctly, DO NOT install the remote control unit in the following places:
In direct sunlight
•
Behind a curtain or other places where it is covered
•
More than 26 feet (8 m) away from the air conditioner
•
In the path of the air conditioner's airstream
•
Where it may become extremely hot or cold
•
Where it may be subject to electrical or magnetic noise
•
Where there is an obstacle between the remote control unit and air
•
conditioner (since a check signal is sent from the remote control unit
every 5 minutes)
1. Slide the cover in the direction indicated by
the arrow and remove it.
2. Install two AAA alkaline batteries. Make sure
the batteries point in the direction marked in
the battery compartment.
3. Use a thin object such as the tip of a pen to
press the ACL button.
Receiver
(Transmitter head)
OI-330-10EG