Acer U5530 User Manual page 88

Appendices
The screw on the

lamp cover and the
lamp cannot be
removed.
The projector

cannot be turned
on if the lamp
cover has not been
placed back on the
projector.
Do not touch the

glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the " " button on the remote
control or on the Control Panel of the projector.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Press the release button to disengage the lamp cover from the main unit. 1
5. Use your fingernail to pry the lamp cover loose and then remove it. 2
6. Unscrew the two screws on the lamp module. 3
7. Lift up the lamp handle 4 and remove the lamp module slowly and carefully. 5
To replace the lamp module, reverse the previous steps.
10. Turn on the projector and reset the lamp timer.
Lamp Reset: (i) Press "Menu"  (ii) Select "OPTIONS"  (iii) Select
80
English
"Lamp Settings"  (iv) Select "Lamp Reset"  (v) Select "Yes".
3
4