Summary of Contents for IBASE Technology BYTEM-W071-PC
Page 1
Manual BYTEM-W071-PC BYTEM-101-PC BYTEM-121-PC iBASE Our company network supports you worldwide with offices in Germany, Austria, Switzerland, Great Britain and the USA. For more information please contact: FORTEC Elektronik AG FORTEC Elektronik AG Hauptniederlassung Büro West Lechwiesenstr. 9 Hohenstaufenring 55 86899 Landsberg am Lech 50674 Köln...
Page 2
BYTEM-xx1-PC User Manual IBASE Technology Inc.
BYTEM-xx1-PC User Manual Table of Contents Safety Information ....................iii Setting up your system ....................... iii Care during use ........................iv Acknowledgments ....................... v CHAPTER 1 INTRODUCTION ..................1 1.1 General Description ....................... 1 1.2 System Specification ...................... 2 1.2.1 Hardware Specifications ..................... 2 1.2.2 Dimensions .........................
BYTEM-xx1-PC User Manual Care during use Do not walk on the power cord or allow anything to rest on it. Do not spill water or any other liquids on your system. When the system is turned off, a small amount of electrical current still flows. Always unplug all power, and network cables from the power outlets before cleaning the system.
The BYTEM series supports a wide-range 9V~30V DC power input for 10.1-inch and 12.1-inch models, using an 84W power adaptor, and 12V DC power input for 7-inch unit with a 60W power adaptor which makes it ideal for factory automation or any other industrial applications. BYTEM-W071-PC overview BYTEM-101/121-PC overview...
1 x DP port 2 x Gigabit LAN (RJ45) 1 x 3-pin DC power connector (1 x DC power jack for BYTEM-W071-PC) 1 x Power on/off switch, power on LED / HDD LED 1 x 2.5” half-size SATA HDD with easy accessibility; Default 32G SSD for...
1.2.3 I/O View BYTEM-W071-PC I/O side BYTEM-101/121-PC I/O side 1.3 Accessory List Part No. Description Quantity 3-pin terminal block for DC in for 1 pc BYTEM-101/121-PC 1 pc 60W Adaptor for BYTEM-W071-PC only 1 pc 84W Adaptor and power cord (option)
BYTEM-xx1-PC User Manual CHAPTER 2 MOTHERBOARD INTRODUCTION 2.1 Introduction IB897 is a 3.5-inch single board computer based on the Intel® AtomTM E3800 series processor. It supports two DDR3L (1.35V) SODIMM sockets for a maximum memory capacity of 8GB. IB897 features Intel's 7th generation (Gen 7) graphics engine and has both CRT and DisplayPort video display interface, as well as 24-bit LVDS dual channel interface with the use of the NXP PTN3460 device.
BYTEM-xx1-PC User Manual 2.3 Setting Jumpers Jumpers are used on IB897 to select various settings and features according to your needs and applications. Contact your supplier if you have doubts about the best configuration for your needs. The following shows the jumpers/connectors on IB897. Jumper Locations on IB897...
Page 25
BYTEM-xx1-PC User Manual CN8: DB9 Connector (COM1) Signal Name Pin # Pin # Signal Name DCD, Data carrier detect DSR, Data set ready RXD, Receive data RTS, Request to send TXD, Transmit data CTS, Clear to send DTR, Data terminal ready RI, Ring indicator GND, ground Not Used...
Page 27
BYTEM-xx1-PC User Manual CN1: SATAII /share mSATA/ Connectors CN2: SATAII Connectors SYS_FAN1: SYSTEM Fan Power Connector Signal Name Pin # Ground +12V(500mA) Rotation detection...
Page 33
BYTEM-xx1-PC User Manual J16: VGA Connector (DF11-16DP-2DSA) Pin # Pin # Signal Name Signal Name Ground Green Blue DDCDATA H_SYNC V_SYNC DDCCLK N.C. J17: Digital I/O (signal level 5V) Connector (2.54mm) Signal Name Pin # Pin # Signal Name VCC (500mA) OUT3 OUT1 OUT2...
Page 35
BYTEM-xx1-PC User Manual J20: Power Switch (2mm) Signal Name Pin # Power Switch Ground JP3: LCD Backlight Connector (JST B4B-PH-K-S ) Signal Name Pin # +12V(1A) Backlight Enable Brightness Control Ground...
BYTEM-xx1-PC User Manual CHAPTER 3 BIOS SETUP 3.1 BIOS Introduction The BIOS (Basic Input/Output System) installed in your computer system’s ROM supports Intel processors. The BIOS provides critical low-level support for a standard device such as disk drives, serial ports and parallel ports. It also password protection as well as special support for detailed fine-tuning of the chipset controlling the entire system.
BYTEM-xx1-PC User Manual CHAPTER 4 DRIVERS INSTALLATION IMPORTANT NOTE: After installing your Windows operating system, you must install first the Intel Chipset Software Installation Utility before proceeding with the drivers installation. 4.1 Intel Chipset Software Installation Utility The Intel Chipset Drivers should be installed first before the software drivers to enable Plug &...
BYTEM-xx1-PC User Manual 4.3 Realtek High Definition Audio Driver Installation 1. Insert the DVD that comes with the system. Click Intel and then Intel(R) Baytrail Chipset. Click Realtek High Definition Audio Driver. 2. On the Welcome screen, click Next to proceed with the installation. 3.
BYTEM-xx1-PC User Manual 4.5 Intel Trusted Execution Engine Installation Note :Windows 7 OS only 1. Insert the DVD that comes with the board. Click Intel(R) TXE Driver.
Page 59
BYTEM-xx1-PC User Manual 4.6 Intel USB 3.0 Drivers Installation 1. Insert the DVD that comes with the system. Click Intel(R) USB 3.0 Driver. 2. On the Welcome screen, click Next to proceed.
Page 61
BYTEM-xx1-PC User Manual 4. Click Next to accept the setup progress. 5. Setup is complete. Click Finish to restart the computer and for changes to take effect.
Page 63
BYTEM-xx1-PC User Manual B. Interrupt Request Lines (IRQ) Peripheral devices use interrupt request lines to notify CPU for the service required. The following table shows the IRQ used by the devices on board. Level Function IRQ0 System Timer IRQ3 Serial Port #2 IRQ4 Serial Port #1 IRQ 10...
Page 65
BYTEM-xx1-PC User Manual File of the MAIN.CPP //--------------------------------------------------------------------------- // THIS CODE AND INFORMATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY // KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE // IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR // PURPOSE.
Page 69
BYTEM-xx1-PC User Manual File of the NCT5523D.CPP //--------------------------------------------------------------------------- // THIS CODE AND INFORMATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY // KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE // IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR // PURPOSE.
Page 73
BYTEM-xx1-PC User Manual File of the MAIN.CPP. //--------------------------------------------------------------------------- // THIS CODE AND INFORMATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY // KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE // IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR // PURPOSE.
Page 75
BYTEM-xx1-PC User Manual File of the NCT5523D.CPP //--------------------------------------------------------------------------- // THIS CODE AND INFORMATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY // KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE // IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR // PURPOSE.
Page 78
Our company network supports you worldwide with offices in Germany, Austria, Switzerland, Great Britain and the USA. For more information please contact: FORTEC Elektronik AG FORTEC Elektronik AG Hauptniederlassung Büro West Lechwiesenstr. 9 Hohenstaufenring 55 86899 Landsberg am Lech 50674 Köln Telefon: +49 (0) 8191 91172-0 Telefon:...