Advertisement
Quick Links
SERVICE PARTS
78980T-DR
40MM Bath Shower Valve With Diverter
78981T-DR
40MM Shower Only Valve
78980T-DR:1293992**
**Color code must be specified when ordering
1293177-AN2-B
48694
3006991
3012353
1311226
INSTALLATION INSTRUCTIONS
78980T-DR
78981T-DR
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. The dimension from the finished wall to the centerline of the valve decided by the trim selection.
2. An inline water filter must be used with this product.
3. Flush the water supply pipes thoroughly to remove debris.
4. Observe all local plumbing and building codes.
5. Shut off the main water supply.
6. Do not remove the rubber protectors from the valve body until instructed to do so.
7. Check for leaks before covering the pipes, repairs as needed.
8. Inlet & outlet threads of valve are Rc1/2˝.
9. Please ensure only apply water pressure test on the product, and empty the air in pipe and faucet thoroughly
before the test. Please ensure test pressure below 0.8MPa(8bar) and test duration within 30 minutes.
10. All installations should comply with the relevant requirements of AS/NZS 3500.
HANDLE OPERATION
For 78980T-DR, lift diverter, turn clockwise until it stops for shower, turn counter-clockwise until it stops for bath
spout.
ROUGH-IN DIMENSIONS
4
1293177-AN2-B
40MM Bath Shower Valve With Diverter
40MM Shower Only Valve
Decided by trim selection
Rc1/2˝
Centerline of valve
48
14
58
Ground
78981T-DR
1
Advertisement
Related Manuals for Kohler 78980T-DR
Summary of Contents for Kohler 78980T-DR
-
Page 1: Installation Instructions
10. All installations should comply with the relevant requirements of AS/NZS 3500. 3006991 HANDLE OPERATION 3012353 For 78980T-DR, lift diverter, turn clockwise until it stops for shower, turn counter-clockwise until it stops for bath spout. 1311226 ROUGH-IN DIMENSIONS Decided by trim selection Rc1/2˝... - Page 2 Be sure the valve body(1) is in correct direction. During Do not use abrasive cleaners or solvents on Kohler faucets and fittings. installation, keep valve protectors(2) on valve body. The Min. and Max. dimensions between the centerline of the valve and the outside of the finished wall are decided by trim selection.