Advertisement
5.0 Tubing Attachment
Original tubing assembly can be reused if undamaged. When cutting a new section of
®
Movotec
Flexible Hydraulic Tubing to required length, make sure any cuts made are
square and clean. Tubing length must not exceed 196 inches (5m). Slide compression
nut and ferrule onto tubing. NOTE: If a CB cylinder is used, slide plastic cap over tubing
end first as shown below.
To attach tubing to cylinder, insert tubing end into cylinder port. While maintaining a
slight downward pressure on tubing, slide compression nut and ferrule down into port.
Re-tighten compression nut to 84-88 lbf-in (9.5-10 N-m) torque. NOTE: For a CB
cylinder, slide plastic cap down tubing and insert into CB cylinder housing.
For this step, a container will be required to collect fluid. Hold the open end of flexible
tubing over the container. With cylinder in upright position, completely compress
cylinder rod. This action will expel fluid from the cylinder and fill the flexible tubing with
fluid.
Before reconnecting tubing to pump, make sure that the cylinder is
completely compressed. Slide compression nut and ferrule onto free
end of tubing. Insert free tubing end into pump port. While maintaining
a slight downward pressure on tubing, slide compression nut and
ferrule down into port. Re-tighten compression nut to 84-88 lbf-in (9.5-
10 N-m) torque.
6.0 Operation
Once all cylinders have been refilled and tubing connections are made as needed, re-attach the pump to workstation.
Crank driven systems should now be fully operational and ready for normal use.
For motorized systems, re-attach motorized pump to the workstation. Re-connect the motor cable to the controller. Finally,
connect power cord to a power receptacle. The controller should make an audible "double-clicking" sound. The motorized
system should now be fully operational and ready for normal use.
Rev. 072514 aj
COMPRESS CYLINDER COMPLETELY
Page 5 of 7
CB Cylinder Shown
©2013 HAUSMANN INDUSTRIES, INC.
Advertisement
