Advertisement
Once the system has reached the "zero" position, unplug power
cord from the power outlet. Then disconnect motor cable from
controller (keep cables plugged in to back of motor drive).
2.2 Cylinder Preparation
®
To properly refill a cylinder, the load must be removed from all cylinders and/or the workstation. For Movotec
"Bolt-On" lift
systems, this can be achieved by lifting the entire workstation off of the floor with a lift truck or pallet jack. Blocks can be
used to stabilize the workstation during the refill procedure.
®
For Movotec
ATU and Corner Leg systems, lift cylinder(s) that are to be refilled must be removed from their corresponding
®
support leg. Movotec
ATU lift systems will require external retaining ring pliers to remove the 13mm retaining ring from the
®
top of the lift cylinder. For Movotec
Corner Leg lift systems, a T25 torx driver will be required to remove (4) torx screws at
the top of the corner leg support housing. Additionally, external retaining ring pliers will be required to remove a 13mm
retaining ring and upper cap from the top of the lift cylinder.
ATU Cylinder Removal Corner Leg Cylinder Removal
Rev. 072514 aj
Page 3 of 7
©2013 HAUSMANN INDUSTRIES, INC.
Advertisement
