Troubleshooting - Sanitaire SC6070 Series Owner's Manual

TROUBLESHOOTING

SYMPTOM:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
SYMPTOM:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
SYMPTOM:
Problem: Hose not connected tightly to wand or machine.
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
10
Unit will not turn on.
Not plugged in.
Plug machine in proper outlet.
Circuit breaker has popped.
Reset circuit breaker. Make sure no other items are running on the
same circuit as machine. Outlet must be a 20-amp circuit.
Power cord has become disconnected from extension cord.
Reattach power cord to extension cord.
Pump is not running properly.
Power cord and extension cord are not completely locked together.
Snap firmly together.
Jets on wand are clogged.
Clean jet with soft wire brush or remove jet and flush clean.
The solution tank is empty.
Fill the solution tank up with a pre-mixed detergent.
Pump is pulsating.
Tighten all hoses. Check for leaks.
Vacuum motor not working properly.
Connect hose tightly.
Hose is clogged with hair, carpet fibers and/or debris.
Clean hose.
Drain plug is not shut completely.
Close drain plug completely.
Vacuum tank lid is not on tightly.
Secure the vacuum tank lid on tightly.
Vacuum tank lid is cracked.
Replace the vacuum tank lid.
Vacuum hose is cracked or split.
Replace vacuum hose.
Water is coming out of the vacuum motor.
Use a low foaming detergent.