Configuring The Acuity - Curtis Acuity 1030 Manual

3 — ACU-SET SOFTWARE
8

Configuring the Acuity

The Acuity needs to be configured to match the battery on which it is installed.
Begin by clicking on the Config tab at the top of the screen.
”
There are three methods of configuration.
1 Click on the pull-down menu entitled Batt Type and select the
battery type that matches your battery. Enter ID (Batt ID),
voltage (Batt Rated Volt), capacity (Batt Rated Ah) and empty
point (Depth of Disch). Click
. Note: For depth of discharge, if desired empty point is
Charge
20% state-of-charge, enter 80. See explanation on page 21.
A dialog box will open to indicate that the Acuity has been
configured successfully. Click
configuration will be loaded into the column on the left.
Note: The table on the right side of the screen is used for
internal purposes only.
2 A configuration file that has been previously stored on the
computer can be retrieved and programmed into the Acuity.
Click on
Load from File
file, and click
The parameters of that configuration will be loaded into
the right-hand column of the table on the left side of the
screen. Click on
A dialog box will open to indicate that the Acuity has been
configured successfully. Click
3 Use the other fields in the Config tab.
Read Parameters
displays them into the column on the left of the table. This
feature allows the user to determine how an existing Acuity is
configured when newly connected to the computer.
Copy Values
from an Acuity to a computer. After the parameters are read
from the Acuity, the
Configure
and the parameters of that
OK
, select the appropriate configuration
. Configuration files use the extension .Acfg.
Open
button.
Configure
.
OK
Reads all parameters from the Acuity and
This function is used when copying parameters
button activates the copying of
Copy Values
Curtis 1030 Acuity Manual,
, then click
Reset State of
Rev. C