Presetting Stations; Recalling A Preset Station; Volume And Tone Control - Sangean WR-2 Operating Instructions Manual

Presetting stations

There are 5 memory presets for each FM and MW wavebands.
1. Press the On/Off button to turn on the radio.
2. Tune to the required station using one of methods
previously described.
3. Press and hold down the required Preset button until the radio
beeps (greater than 2 seconds). The preset number will appear
in the display and the station will be stored under the chosen
preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories may be overwritten by
following the above procedure.

Recalling a preset station

1. Press the On/Off button to turn on the radio .
2. Select the required waveband by repeatedly pressing the
Band button .
3. Momentarily press the required Preset button, the preset number
and station frequency will appear in the display .

Volume and Tone control

1. Rotary the volume control knob to set the required volume level,
display will show volume level ( maximum to 60 )
2. Press Volume control once to get into Treble control.
Rotary the control until required treble is reached .
3. Press Volume control twice to get into Bass control.
Rotary the control until required bass is reached.
15