Garmin GTX 330D Maintenance Manual page 30

Function Display
FLIGHT ID
UP COUNTER
DOWN COUNTER
FLIGHT TIMER
TRIP TIMER
PRESSURE ALT
ALT MONITOR
SAT/DALT
CONTRAST/OFFSET
BACKLIGHT/OFFSET
MESSAGES
BLUETOOTH
INTERNAL GPS
1090ES TX CTRL
190-00734-11
Rev. 6
If ALLOW PILOT TO EDIT FLT ID is configured to YES, the FLIGHT ID
can be changed by the pilot at any time in normal mode. This allows the pilot/
crew to enter the specific flight ID for transmission to ATC interrogations.
Timer controlled by ENT and CLR keys.
Timer controlled by ENT, CLR, and CRSR keys. The initial count down time
is entered with the 0 – 9 keys.
Displays the Flight Time, controlled by the ENT key or by one of four
airborne sources (squat switch, GPS ground speed recognition, air data
airspeed recognition, or altitude increase) as configured during installation.
The timer begins when the GTX 3X5 determines that the aircraft is airborne.
Timer controlled by ENT and CLR keys.
Displays the altitude data supplied to the GTX 3X5 in feet, hundreds of feet
(flight level), or meters, depending on configuration.
Controlled by ENT key. Activates a voice alarm and warning annunciator
when altitude limit is exceeded.
Displayed when the GTX 3X5 is configured with temperature input. Displays
Static Air Temperature and Density Altitude.
Contrast is controlled by the 8 and 9 keys.
This page is only displayed if photocell backlighting mode is selected in
Configuration mode. Backlighting is controlled by the 8 and 9 keys.
Alerts crew of transponder faults, fails and advisory messages. MSG appears
when a message is generated. CRSR and ENT keys access messages for
acknowledgment and viewing.
This page is only displayed on the GTX 345 when configured for Bluetooth at
installation. When enabled, allows PED pairing to the GTX 345 and device
management for display of ADS-B In data.
This page displays Lat/Long accuracy, number of connected satellites,
horizontal figure of merit, whether the unit is using internal GPS, and overall
status.
This is only displayed when the unit is configured for 1090ES OUT
CONTROL in Configuration mode to be PILOT SET. Once configured, this
can be highlighted by the CRSR key, changed by the 8 and 9 keys, and
selected by ENT key. Turns the extended squitter function on or off.
GTX 33X and GTX 3X5 ADS-B Maintenance Manual
Page 3-7