Advertisement
Installation:
1. Remove the front cover of the pushbutton by inserting a paperclip in the notch at the top of
the unit. Push down on the paperclip with force and pull the top of the front cover from the
pushbutton.
2. Mount the pushbutton to a wall or other surface using screws (not included) through the two
mounting holes.
3. Once the pushbutton has been mounted, snap the front cover onto the unit.
Pairing the Pushbutton:
1. Follow the pairing instructions for the RA-4961-K1Q receiver or RA-4961-VPQ wireless
vibrating receiver to enter pairing mode. (Refer to RA-4961-K1Q or RA-4961-VPQ manual for
detailed instruction).
2. Press the pushbutton.
3. The receiver will beep once and cycle to the next channel to confirm successful pairing.
Installing the Battery:
1. Remove the front cover of the pushbutton by inserting a paperclip in the notch at the top of the
unit. Push down on the paperclip with force and pull the top of the front cover from the
pushbutton.
2. If there is a previous battery installed, use a fingernail or small object to remove the battery
from the battery holder.
3. Slide a CR2032 battery into the battery holder, making sure to observe correct polarity
(positive faces out).
4. Snap the front cover onto the pushbutton.
Note: Low battery is indicated on the receiver. Refer to the RA-4961-K1Q or RA-4961-VPQ for more information.
SECO-LARM U.S.A., Inc.
Insert paperclip
Remove cover
in notch
Insert paperclip
Remove cover
in notch
CBA Wireless Pushbutton
Mounting
holes
Battery
holder
3
Advertisement
