Network Configuration; Pinning Tyco Mqs - I-novative 2-Port OABR Multi-Media-Switch User Manual

2.4. Network Configuration

In principle, the OABR Multi-Media-Switch acts as a standard switch in a network. This means:
a) for the participation of the PC via the OABR switch on this network, the PC must have the same
subnet mask as well as a valid IP address. b) Please make sure that no IP address is assigned
twice. Sniffing in the network (e.g., via Wireshark) requires no special setting on the PC.

2.5. Pinning Tyco MQS

Explanation of the connections:
• HighSpeed CAN High/Low
• U_Bat
• GND
• ETH_ON
• OABR +/-
• OABR Shield
High Speed CAN - Low 18
U_BAT 17
ETH_ON
OABR Port2- 14
OABR Port2+ 13
OABR Shield 12
OABR Port1- 11
OABR Port1+ 10
Connection of the Higspeed CAN. Please pay attention
to the correct termination of your CAN bus.
Power supply 12V
Ground
The port is bi-directional. The OABR-Switch
can be configured that in case of a positive signal level
the devices wakes up. The pulse width can be
configured. Additionally, over the GUI, a trigger signal
can be sent. The signal level is GND (default) until
U_BAT. In mode „Always On", the input trigger signal is
ignored, the device is always active.
OABR connectors
On this pins - if necessaary - a cable shield can be
connected. The Shield is connected to the housing
via a RC-Filter.
9 High Speed CAN - High
8 GND
16 7 GND
15 6
5
4
3 OABR Shield
2
1
page 9