Commissioning And Configuration; Commissioning And Connection - I-novative 2-Port OABR Multi-Media-Switch User Manual

2. Commissioning and configuration

2.1. Commissioning and connection

Step 1
Connect your OABR Multi-Media-Switch to the existing test environment using the interface cable.
If you do not have an i-NOVATIVE original cable, you can do your own cable wiring according to
the description of pinning in chapter 2.5. Connect the two OABR ports of the OABR Multi-Media-
Switch to the OABR ports of the devices to be connected.
Make sure that the power supply is within the specified range and connect the two CAN Bus lines.
Please note that the correct CAN connections (CAN-High, CAN-Low) are used due to the CAN
bus can be disturbed by incorrect connection. If necessary, check the correct configuration based
on the pinning (2.5.).
Step 2
Connect your PC to a USB-A cable or RJ45 Ethernet cable and proceed with section 2.2. (Soft-
ware installation and driver installation). Alternatively, the OABR Multi-Media-Switch can also be
connected to the PC via a standard network switch and the Ethernet cable
page 4