Advertisement
Installation:
Note: Figs 20 & 21 bows folded back to rear of vehicle. Rear corner shown.
FIG 20
Cable Anchor
Step 6: Header Corner Pockets
Slip the corner pocket sewn into the top
between the header and position the
cable anchors over the two holes with
the cable facing the outside of the
header (Fig 20 & 21).
FIG 22
Cable Anchor Foam
FIG 23
FIG 21
Fabric Pocket fits over Header
Step 7: Install Header Foam
Strip Foam
Locate the Header foam packet and
attach foam over the installed cable
anchors on each side of the header.
Install the small "strip" foam on
the front of the header as shown
in Fig 22.
Step 8: Drape the Top Fabric
Drape the top fabric over the cab rein-
stalling and securing the bow assembly
above the door. The front header should
be resting on the windshield but not
attached/clamped and the top fabric
should be laid back but not attached
to the rear bows. See Fig 23
®
The Trusted Source
7
Advertisement
