Reversible Door Exchange - IDW G-10F Instruction Manual

Instruction Manual
DOOR REVERSAL (For G-10f Coolers Only)
Delete clause 1 in the left and adjust the
rest clause Seiral No and content as below:
1 Remove the front grill, disconnect the terminals and then hide
reversible d oor e xchange
the terminals in the door's reserved hole.
1.Remove the front grill, disconnect the
terminals and then hide the terminals in
the door's reserved hole.
2.Remove upper hinge and bottom door
limit,then remove the door.
1.disassemble t he t he h inge l atch o f l eft h and d oor.
2. d isassemble t he f ront g rill, d isconnect t he t erminals,
then h ide t he t erminals i nto d oor's r eserved h ole.
remark: please add the above picture under
the No1 picture.
2 Remove the right upper hinge and bottom door limit,then
remove the door.
3.Take out the torsion rod from the upper
3.disassemble t he r ight u pper h inge, t hen r emove t he
of the door right
door.
4.Fish out the wiring from door frame
cavity, the wiring stretches out from the
upper of door right.
5.Insert the torsion rod into corresponding
holes on bottom right of the door.
6.Rotate the door clockwise 180°(Now the
wiring is stretching out from the bottom
4.draw o ut t he s tructure o f s elf-­‐closing d oor,then
assemble t he s tructure i nto d oor o ther s ide .
6 Rotate the door clockwise 180°, so the wiring is
5.clockwise r otate t he d oor 1 80°.
7 Remove the hinge axis from the right bottom hinge,
6.draw o ut t he h inge a xis f rom r ight b ottom h inge, i nsert
it i nto l eft b ottom h inge.
7.The t erminals o f d oor L ED l ights w iring i s t aken o ut f rom
3 Take out the torsion rod from the upper right of the
door.
4 Fish out the wiring from door's reserved hole, the
wiring stretches out from the upper right of door.
5 Insert the torsion rod into corresponding holes on
bottom right of the door.
stretching out from the bottom left of the door.
inert it into the left bottom hinge.
11