Troubleshooting - Whirlpool WRF954CIHV Use And Care Manual

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service
call, refer to the warranty page in this manual and scan the code with your mobile device, visit producthelp.whirlpool.com, or call
1-800-253-1301. In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Refrigerator Operation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If you experience
The refrigerator will not
operate.
36
20-Jun-2017 10:09:25 EDT | RELEASED

TROUBLESHOOTING

First try the solutions suggested here or visit our website at producthelp.whirlpool.com.
WARNING
Possible Causes
Check electrical supply.
Check controls.
New installation
Refrigerator control is in Demo mode
(on some models).
In some European factories the letter "W" of the part code mentioned herein will be automatically
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 – 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Solution
Plug the power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Make sure there is power to the outlet. Plug in a lamp to see if
the outlet is working.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Make sure the controls are turned on. See the "Tools" section.
Allow 24 hours following installation for the refrigerator to cool
completely.
NOTE: Adjusting the temperature controls to the coldest setting
will not cool either compartment more quickly.
If the refrigerator is in Demo mode, cooling is turned off and
"Demo" will be illuminated on the control panel. See the "Tools"
section for more information.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")